Hello Storey,
Thank you for sharing your software. I can not tell you how frustrated I have been sticking the wires into the plug to pump up the springs and compressor. It took a few tries to reset even though all three apps would sync.
Finally with the calibration software and the engine running and after testing the height modes it did. Needless to say I was very happy. It is now functioning perfectly. I did make my own cable and stuck the foolish striped wires into the diagnostics plug. Sorry I just could not wait to try it!
I am ordering your cable if for nothing else than to support your efforts. again

Thank You
Bill



The information provided herewith is on "AS IS" basis without warranties of any kind either express or implied. RSW Solutions nor any affiliate guarantee the completeness, usefulness or accuracy of any information provided herewith either related to RSW Solutions LLC or any of the links that are referenced from this Web site. However, the information provided herewith is purely intended for your reference and information and does not express, nor intend to provide any opinion or advice or endorsement of any kind to the services provided by the organizations referenced in this Web site. Your use of this Web site (www.RSWsolutions.com) is at YOUR RISK. IN NO EVENT SHALL RSW Solutions LLC, OR ITS affiliates BE LIABLE FOR ANY LOSS OR INJURY OR DAMAGES, either direct, indirect, punitive, incidental, special incidental, or otherwise, resulting from or connected to the use of the www.RSWsolutions.com web site. YOU HEREBY WAIVE ANY AND ALL CLAIMS AGAINST RSW Solutions ARISING OUT OF YOUR USE OF THE SITE OR ANY OTHER INFORMATION PROVIDED ON THIS SITE (www.RSWsolutions.com).

Disclaimer: Land Rover, Range Rover and Rover are registered trademarks of Land Rover North America, Inc.. This website has no affiliation with Land Rover North America, Inc.