eas_rearsensor_front

eas_rearsensor_scaled

 

The EAS suspension relies almost entirely on the height sensors for empirical data on the outside world. These sensors are a feedback for several assumptions that the EAS ECU makes on the condition of the suspension system. Any failure of a sensor will trigger an EAS Fault.

The EAS height sensor is a Potentiometer fed with a regulated 5v reference signal. This reference voltage is then modified by the resistive Potentiometer and a voltage is fed back into the EAS ECU. The modified voltage is then fed into one of the A2D converters on the Motorola 68HC05 microprocessor. The 0-255 Digital value of the sensor voltage is then used to determine the exact position of that sensor and the height of the suspension.

The potentiometer inside the EAS height sensor can develop dead spots over time. These dead zones result in an inaccurate or a nonresponsive reading back to the EAS ECU. If the ECU tries to raise a corner of the vehicle and there is not a corresponding change in the height sensor then an EAS fault can be logged. The EAS ECU has different fault codes for a sensor that has bad reading versus an EAS sensor that is completely disconnected.



The information provided herewith is on "AS IS" basis without warranties of any kind either express or implied. RSW Solutions nor any affiliate guarantee the completeness, usefulness or accuracy of any information provided herewith either related to RSW Solutions LLC or any of the links that are referenced from this Web site. However, the information provided herewith is purely intended for your reference and information and does not express, nor intend to provide any opinion or advice or endorsement of any kind to the services provided by the organizations referenced in this Web site. Your use of this Web site (www.RSWsolutions.com) is at YOUR RISK. IN NO EVENT SHALL RSW Solutions LLC, OR ITS affiliates BE LIABLE FOR ANY LOSS OR INJURY OR DAMAGES, either direct, indirect, punitive, incidental, special incidental, or otherwise, resulting from or connected to the use of the www.RSWsolutions.com web site. YOU HEREBY WAIVE ANY AND ALL CLAIMS AGAINST RSW Solutions ARISING OUT OF YOUR USE OF THE SITE OR ANY OTHER INFORMATION PROVIDED ON THIS SITE (www.RSWsolutions.com).

Disclaimer: Land Rover, Range Rover and Rover are registered trademarks of Land Rover North America, Inc.. This website has no affiliation with Land Rover North America, Inc.